Above: The rear shock mount for the Fox shock. This should
look similar to the custom one that Chris
is using. Above right shows the rear shock mount, similar to the SGII
version, but sized for the heim joint on the Fox shock and with less extension
of the mount.
Stage III: Front Top and Bottom. Top shows the Fox shock mount and reservoir. A hole is cut in the rear of the tower to pass the reservoir through, which can't be seen here. Notice the rust spot on my Fox shock from the tire. I need to turn that one in a bit, I guess.
Bottom shows the lower spring and shock mounts for the front axle and the braided steel brake lines
